removing sliding table

preston · Post by **preston** » Sat Oct 31, 2009 7:21 pm

OK, so how do I get this thing off?
There's a stop near the front (approximately triangular cast-iron part held in place by two Allen-head bolts). I thought that'd do the trick, but no joy. Am I missing something easy?

Thanks,
Preston

crzypete · Post by **crzypete** » Sat Oct 31, 2009 8:50 pm

Once you have the stop removed start bouncing the table towards you, it will start to move in its ways. Since you have a G4 the balls will be loose and each will fall out.

There should be two felt washers on the center balls and there will be a carriage that holds all the balls.

Pete

preston · Post by **preston** » Sun Nov 01, 2009 9:28 pm

Got it. And amazingly enough (this is probably a first in my own personal life), it went back together easier than it came apart.

Thanks,
Preston