MachineJunkie

Good machine looks good, runs good very simular to the Williams & Hussy.
Must have been the original before M.S. Perkins Machine Co. Inc. sold out
Comes with roller stand, 1/2 hp motor, belt and switch. $100.
Email for pictures.
Bruce

bruceandanne@earthlink.net

Before you replace the 3rd fuxe, be sure you check the voltage and Phase!! It looks like the motor has been changed from 3 ph to single ph. If you have not sold the machine would you consider selling the folding rod on the rt side of the saw table? I just bought a nice G44B and could use this part. ...

Pete, mister honey just sent me 3 PDFs showing the Batter Gauge he drew with CAD program and some others. He still has a set of castings available. I purchased a nice 4' 5/16" cold roll steel yesterday. I have some new ideas and will send pictures of the finished Gauges when finished. Thanks ag...

Pete,
Thanks again!
That was to be my next try! I will let you know how it turns out.
Can you walk me through the steps to post pictures?
Bruce

mister honey,
What size hole do you drill in the mounting bracket and or what size shaft is required? Is it the same size on both ends, consentric or what does it look like?
Bruce

Thanks, Pete! I will try a smaller shaft size as I only have one of those little machine lathes with the 3 jaw chuck. If all else fails, I will try a magnetic base with a 3/8" X 32 tpi shaft so each revolution of the shaft would equal 1/32". A half turn 1/64" amd a quarter turn 1/128&...

I have just acquired a nice G4B serial #4894. It has no Batter gage and I have been trying to make one. I have only seen the picture of one in the Oct issue of WOODWORKERS JOURNAL, story by David Fowler. I looked at the 2 mounts on the right side of the table and measured holes to be 7/16" on t...